It’s ok, technical questions include some GD&T, materials, and solid mechanics question, not too hard (have to recap stress strain graph, etc). Also went through resume asking your past experience, and motivation.
Zoom call focused on GD&T. Entire interview was on datums of a part, what controls you would place on it, critical areas, and important things you would want to know in the event of you machining it.
Interview questions [1]
Question 1
Where would you select the three datums for this part and what degrees of freedom does each datum constrain?
failed the first round, only ask about basic knowledge, strain-stress curve, natural vibration. gave me white borad to draw and some follow up questions. average exerpence i would say. hope you good luck