If the source impedance is 50ohms, and you have 2dB of mismatch between the source and load, on what region of the smith chart would the load impedance be found?
Technical Systems Analyst Interview Questions
48,605 technical systems analyst interview questions shared by candidates
You have access to two ports on the RF circuit of a mobile device, one port is at the antenna one at a 50 ohm resistor. Which port will you connect to test the circuit. why describe the advantage and disadvantage of each case.
Equivalent resistance of a resistor cube, with 1ohm resistor on each side.
How many squares in a chess board
1) Introduction 2) Experience from current job. 3) Basic knowledge of FPGA programming languages.
What is used in linux to change file permissions
fibonacci series,about my project
I don't think I was asked any question. As I mentioned above, I'm disturbed by this new requirement where all companies ask you what you make, and what you expect to make.
Questions were not difficult, but were more open ended which allowed for variable depth answers.
Mostly asked about previous experience at past jobs. Not many technical questions.
Viewing 201 - 210 interview questions